
These easy homemade potato chips are thin slices of potato fried until crisp and lightly golden, then finished with salt while they’re still warm. You can make them with Russet or Yukon Gold potatoes and a few simple pantry ingredients.
The key is to slice evenly, rinse away surface starch, dry the slices thoroughly, and fry in small batches at a steady temperature. The result is a delicate crunch with a clean potato flavor; add paprika, garlic powder, or another favorite seasoning if you like.
Why This Recipe Works
Thin, even slices cook at nearly the same rate. A mandoline makes that job quick, but a sharp knife works if you take your time and keep the slices consistent. Aim for about 1/16 inch (1.5 mm): thick enough to handle, thin enough to turn crisp before the edges get too dark.
A brief soak in cold water rinses off some of the starch on the surface. That helps keep slices from sticking together and encourages a cleaner, crisper finish. The soak is only part of the process, though: the slices must be dried very well before they go into hot oil. Water on potatoes can make oil spit, and damp slices tend to steam rather than fry crisp.
Frying in small batches helps the oil stay near 350°F (175°C). If too many slices go in at once, the temperature drops, cooking takes longer, and the chips can absorb more oil. A thermometer makes it easier to control the heat, while color and texture tell you when each batch is ready.
Ingredients
- 2 large potatoes (Russet or Yukon Gold), about 1 1/2 lb (680 g) total
- 4–6 cups (950–1,420 ml) vegetable oil, or enough to fill a heavy pot 1 1/2–2 inches (4–5 cm) deep
- 8 cups (1.9 L) cold water, for soaking
- 1/2 tsp (2.5 ml) fine salt, plus more to taste
- 1/4 tsp (1 ml) paprika, optional
- 1/4 tsp (1 ml) garlic powder, optional
- 2 tbsp (30 ml) vegetable oil, for the oven-baked variation only
Ingredient Notes
Potatoes: Russets are relatively starchy and make a dry, crisp chip. Yukon Golds have a slightly waxier texture and a richer potato flavor; they can turn a little more golden as they fry. Either works. Avoid potatoes that are green, badly sprouted, or soft.
Vegetable oil: A neutral oil with a high smoke point, such as canola, sunflower, or peanut oil, is suitable for frying. Use fresh oil with no off smell. The exact amount depends on the width of your pot; what matters is having a safe depth of oil and room for it to bubble without reaching the rim.
Salt and seasonings: Fine salt clings well to hot chips. Add it just after frying, when the surface is still lightly oily. Paprika and garlic powder are optional; use a light hand at first, since fine powders can taste intense on a thin chip. For a different flavor, try onion powder, black pepper, or a pinch of cayenne.
Soaking water: The water is discarded after soaking, but it helps rinse starch from the cut surfaces. Use cold water and dry every slice before frying.
Instructions
- Wash and slice the potatoes. Scrub the potatoes under cool running water and trim away any eyes or damaged spots. Peel them if you prefer, though peeling is not necessary. Slice crosswise into rounds about 1/16 inch (1.5 mm) thick with a mandoline or sharp knife. Look for slices of similar thickness; uneven pieces will finish at different times. If using a mandoline, use its guard and keep your fingers clear of the blade.
- Soak the slices for 20–30 minutes. Put the slices in a bowl of cold water and separate any that stick together. The water may turn cloudy as surface starch rinses away. Drain the slices, rinse once with fresh water, and drain again. This brief soak helps reduce sticking and supports an even crisp texture.
- Dry the slices completely. Spread the potato slices on a clean kitchen towel or several layers of paper towels, then pat both sides dry. Leave them uncovered for a few minutes if they still feel damp. They should look and feel dry, with no beads of water on the surface. This step helps prevent oil splatter and keeps the chips from steaming.
- Heat the oil to 350°F (175°C). Pour the oil into a heavy, deep pot, leaving plenty of space above it, and attach a deep-fry thermometer if you have one. Heat over medium to medium-high heat until the oil reaches 350°F. The oil should shimmer, not smoke. Keep the pot stable on the burner and keep water away from the hot oil.
- Fry in small batches for about 2–4 minutes each. Add a small handful of slices, separating them as they enter the oil. Do not crowd the pot. Stir gently once or twice with a spider or slotted spoon so the slices cook evenly. Watch for the bubbling to become less vigorous and the edges to turn pale golden. Remove chips when they are crisp-looking but not deeply browned; they continue to darken slightly as they cool. If the oil temperature falls well below 325°F (163°C), let it recover before adding another batch.
- Drain and season immediately. Lift the chips out with a spider or slotted spoon and let excess oil drip back into the pot. Spread them in a single layer on a wire rack set over a tray, or on paper towels. Sprinkle with salt and any optional seasonings while warm. A chip should become crisp as it cools; if it stays flexible, return it to the oil briefly or cook the next batch a little longer.
- Let the oil cool safely. Turn off the heat and leave the pot in place until the oil has cooled completely. Do not pour hot oil down the drain or add water to it. Once cool, strain it into a suitable container if you plan to reuse it, and discard it according to your local waste guidance if it is dark, smells off, or has been used repeatedly.
Tips for Success
- Keep slices consistent. About 1/16 inch is a useful target. A thicker slice may need longer and can stay chewy in the center while its edges brown.
- Dry more than you think you need to. Pat the slices, separate them, and check the surfaces before frying. Moisture is both a splatter hazard and an obstacle to crisping.
- Use a deep, heavy pot. Leave several inches of headroom above the oil so bubbling stays contained. Never fill a pot more than halfway with oil.
- Work in small batches. Give slices space to move. Crowding lowers the oil temperature and makes it harder to spot a chip that is ready.
- Check the oil between batches. Let it return to about 350°F (175°C) before adding more potatoes. If chips brown too quickly, lower the heat slightly; if they take a long time and feel oily, let the oil heat back up.
- Season while the chips are warm. Salt and fine spices stick better before the surface cools and dries.
- Judge crispness after cooling briefly. A hot chip can still feel a little pliable. Give one a short moment on the rack before deciding whether the batch needs more frying.
Troubleshooting
The chips are limp or chewy. They may be too thick, damp, or under-fried. Slice more evenly, dry thoroughly, and fry until the bubbling slows and the chips look crisp. Check one after it cools briefly; if it remains flexible, cook the next batch a little longer.
The chips are greasy. The oil may have cooled too much, or the pot may be overcrowded. Fry fewer slices at a time and let the oil return to 350°F (175°C) between batches. Drain the finished chips in a single layer rather than piling them up.
The chips brown before they crisp. The oil may be too hot, or the slices may be thicker than intended. Lower the heat and check the temperature. Aim for thin, even slices and remove chips at pale gold; they darken a little as they cool.
The slices stick together. Separate them as they go into the oil and avoid adding a large clump at once. Rinsing and drying the slices well also helps reduce sticking.
The oil spits. Stop adding potatoes and step back from the pot. Moisture on the slices or water near the oil is a common cause. Keep the burner area dry, dry the potatoes thoroughly, and never add water to hot oil.
Variations
Oven-baked chips: For a lower-mess alternative, heat the oven to 400°F (200°C). Soak, rinse, and dry the slices as directed, then toss them with the 2 tbsp (30 ml) vegetable oil. Arrange in a single layer on parchment-lined baking sheets, without overlapping. Bake for about 12–20 minutes, turning the slices and rotating the sheets once, until the chips are dry-looking and lightly golden. Thin slices can brown quickly, so begin checking early and remove individual chips as they finish. Season while warm. Oven-baked chips may be less evenly crisp than fried ones.
Simple paprika chips: Stir the paprika into the salt before sprinkling it over the warm chips. This distributes the seasoning more evenly than adding a concentrated pinch to one spot.
Garlic-pepper chips: Combine garlic powder with a little fine salt and black pepper. Sprinkle lightly; powdered seasonings can become assertive on thin slices.
Salt-and-vinegar style: Sprinkle the finished chips with a small amount of vinegar powder if you have it. Avoid soaking already-fried chips in liquid vinegar, which softens them.
What to Serve With It
Serve the chips as a snack on their own, or pair them with a sandwich, burger, or soup. They are also good alongside dips such as onion dip, salsa, or a simple sour-cream dip. If serving a group, put out the chips soon after frying and keep seasonings on the side so everyone can choose a flavor.
Make-Ahead, Storage and Reheating
For the crispest result, fry the chips shortly before serving. You can slice and soak the potatoes up to a few hours ahead; keep the slices submerged in cold water in the refrigerator, then drain and dry them exceptionally well just before frying. Do not leave cut potatoes at room temperature for an extended period.
Cool finished chips completely before packing them, since trapped warmth can create condensation. For the best texture, store thoroughly cooled chips in an airtight container at room temperature and eat them within a day or two. If they have become soft, spread them on a baking sheet and warm them in a 300°F (150°C) oven for 3–6 minutes, watching closely. Let them cool briefly before serving; crispness returns as they cool.
If you need to keep the chips longer, refrigerate them within 2 hours of cooking and use them within 3–4 days, following USDA guidance for cooked leftovers. Refrigeration can make them stale or soft. You can freeze them in a sealed freezer-safe container for 3–4 months, the USDA’s general freezer window for leftovers, but their texture may suffer. Thaw in the refrigerator and re-crisp in the oven; do not refreeze after thawing.
Recipe Card
Servings: 4 snack servings
Prep time: 35 minutes, including soaking
Cook time: 20–25 minutes, depending on batches
Total time: About 55–60 minutes
Ingredients
- 2 large Russet or Yukon Gold potatoes, about 1 1/2 lb (680 g) total
- 4–6 cups (950–1,420 ml) vegetable oil, or enough for a depth of 1 1/2–2 inches (4–5 cm)
- 8 cups (1.9 L) cold water, for soaking
- 1/2 tsp (2.5 ml) fine salt, plus more to taste
- 1/4 tsp (1 ml) paprika, optional
- 1/4 tsp (1 ml) garlic powder, optional
- 2 tbsp (30 ml) vegetable oil, for the oven-baked variation only
Condensed steps
- Slice scrubbed potatoes into even rounds about 1/16 inch (1.5 mm) thick.
- Soak in cold water for 20–30 minutes; rinse, drain, and dry the slices completely.
- Heat frying oil to 350°F (175°C) in a deep, heavy pot, leaving plenty of headroom.
- Fry small batches for 2–4 minutes, stirring gently, until bubbling slows and chips are pale golden and crisp-looking.
- Drain in a single layer and season while warm. Cool briefly to check crispness.
Frequently Asked Questions
Do I need a mandoline to make potato chips?
No. A mandoline makes even slices quickly, but a sharp knife works too. Take care to keep the rounds close to 1/16 inch (1.5 mm) thick so they cook at a similar rate. Use a mandoline guard if you have one.
Should I peel the potatoes?
Peeling is optional. Scrub the potatoes well and leave the skins on for a more rustic chip, or peel them for a smoother finish. Remove eyes and any damaged or green areas before slicing.
Which potatoes are better, Russet or Yukon Gold?
Both work. Russets tend to make a drier, crisp chip, while Yukon Golds have a richer flavor and can turn more golden. Slice either variety thinly and dry it well before frying.
Why soak the potato slices?
Soaking rinses some surface starch from the slices. That can help reduce sticking and support an even finish. It does not replace drying: pat the slices completely dry before they meet hot oil.
Can I fry the chips without a thermometer?
Yes, but a thermometer makes it easier to hold the oil near 350°F (175°C). Without one, work cautiously over medium to medium-high heat and fry a small test slice. It should bubble steadily without browning almost immediately. Adjust the heat as needed, and never leave hot oil unattended.
Can I use a different oil?
Use a neutral oil that is suitable for high-heat frying, such as canola, sunflower, or peanut oil. Avoid oils that smoke at frying temperatures or have a strong flavor you do not want on the chips.
How can I tell when a chip is done?
Look for slower bubbling, dry-looking surfaces, and pale-golden edges. Remove the chips before they become deeply brown, since they continue to darken slightly after leaving the oil. Let one cool briefly; it should crisp as it cools.
Can I season the chips before frying?
Season them after frying. Salt and powdered spices can burn or fall off in hot oil. Sprinkle them over the chips while they are warm so the seasoning adheres.