Homemade taco seasoning is a simple blend of chili powder, cumin, garlic, oregano, and other pantry spices that brings warm, savory flavor to tacos. Mix a batch in minutes, then use it to season a pound of ground beef for an easy taco filling; adjusting the salt and heat lets you make it your own.
Ingredients
- 1 tablespoon chili powder
- 1 1/2 teaspoons ground cumin
- 1 teaspoon paprika, sweet or smoked
- 1 teaspoon garlic powder
- 1 teaspoon onion powder
- 1 teaspoon fine salt
- 1/2 teaspoon dried oregano
- 1/2 teaspoon ground black pepper
- 1/4 teaspoon cayenne pepper, or less to taste
- 1 pound ground beef
- 1/3 cup water
- 1 teaspoon neutral oil, only if needed for the pan
The spice blend makes about 3 tablespoons, enough for 1 pound of ground beef. The salt amount assumes fine table salt; if using a coarse or flaky salt, start with less and adjust after cooking. For a lower-sodium mix, use 1/2 teaspoon salt or leave it out and season the filling to taste.
Instructions
- Combine the spices. In a small bowl, stir together the chili powder, cumin, paprika, garlic powder, onion powder, salt, oregano, black pepper, and cayenne. Break up any lumps so the blend is even. If you are making the seasoning ahead, transfer it to a clean, dry, airtight jar. The mix is ready to use as soon as it is combined.
- Brown the beef. Set a large skillet over medium-high heat. Add the ground beef, breaking it into small pieces with a spoon or spatula. If the beef is very lean or begins sticking, add the teaspoon of oil. Cook, stirring and breaking up the meat, until it is browned and no longer pink. Check the thickest pieces with a food thermometer; ground beef should reach 160°F.
- Drain excess fat if needed. If there is a large amount of grease in the pan, carefully spoon it off or drain it into a heat-safe container. A little fat helps carry the spices and keeps the filling from tasting dry, so there is no need to remove every trace. Take care when handling hot grease, and do not pour it down the sink.
- Add the seasoning. Sprinkle the full batch of taco seasoning over the beef and stir until the meat is evenly coated. Pour in the water and scrape the bottom of the skillet to loosen browned bits. Those bits add flavor to the sauce, so scrape gently without damaging a nonstick pan.
- Simmer until saucy. Reduce the heat to medium-low and cook for 2 to 4 minutes, stirring occasionally, until the water has mostly reduced and the seasoning clings to the meat. If the filling looks dry before the flavors have blended, add water 1 tablespoon at a time. If it seems too loose, simmer another minute or two.
- Taste and serve. Taste a small spoonful and adjust with a pinch of salt, black pepper, or cayenne if needed. Spoon the beef into warm tortillas or taco shells and add your chosen toppings. For another protein, prepare the same seasoning separately and cook the meat to the appropriate safe temperature: ground turkey or chicken should reach 165°F.
Tips
- Know your chili powder. In many U.S. grocery stores, chili powder is a mild seasoning blend, not pure ground chile. Its heat and salt content can vary by brand. Taste a tiny pinch before mixing, and reduce the cayenne if your chili powder is already hot. If you use pure chile powder instead, start with less because it may be much more concentrated.
- Bloom the spices in the pan. Adding the blend to browned meat with a little water distributes it evenly and prevents dry spice from clumping. You can stir the seasoning into the beef for about 30 seconds before adding water, but keep it moving; ground spices can scorch if left against a hot, dry pan.
- Adjust salt after cooking. Salt preferences differ, and toppings such as cheese, salsa, and pickled vegetables can add more. Starting with the recipe amount gives the beef a rounded flavor, but a reduced-salt batch is easy to correct at the table. Add small pinches, taste, and stop when the meat tastes balanced.
- Keep the mix dry. Use a dry measuring spoon and a completely dry jar. Moisture can make the blend clump and shorten its useful storage time. Label the jar with the date and, if helpful, note whether you used smoked or sweet paprika so you can repeat the flavor you liked.
Serving Suggestions
Serve the seasoned beef in warm corn or flour tortillas, crisp taco shells, or lettuce cups. Add shredded cabbage or lettuce for crunch, diced tomato, sliced avocado, grated cheese, chopped onion, or fresh cilantro. Lime wedges bring a bright, tart contrast to the savory filling. Offer salsa, hot sauce, or plain yogurt or sour cream at the table so everyone can choose how much heat and creaminess to add.
This filling also works beyond tacos. Spoon it over rice for a quick taco bowl, tuck it into a quesadilla with cheese, or layer it into nachos with beans and vegetables. If serving a group, keep the meat warm in a covered dish and put toppings in separate bowls. Warm tortillas just before eating; a short warm-up makes them more flexible and less likely to crack as you fill them.
Variations
Milder blend: Leave out the cayenne and use a mild chili powder. You can also reduce the black pepper slightly. The cumin, garlic, and oregano will still give the seasoning a savory, recognizable taco flavor without relying on extra heat.
Smokier flavor: Use smoked paprika in place of sweet paprika. For more depth, replace up to half of the chili powder with a mild ground ancho chile, if available. Ground chile is not always as mild as a commercial chili powder blend, so make a small adjustment and taste the cooked filling before adding more.
For chicken, turkey, or beans: Use the same spice blend with ground poultry, diced chicken, or a drained can of beans. For diced chicken, cut it into even pieces so it cooks evenly, and verify that poultry reaches 165°F. For beans, warm them with the seasoning and a splash of water until hot and well coated; mash a few beans if you want a thicker filling.
Make it salt-free: Omit the salt from the jar and season the cooked filling to taste. This makes the blend easier to use with ingredients that are already salty, such as canned beans or packaged broth. Keep the rest of the ratios the same, then add salt gradually when you prepare each meal.
Storage and Reheating
Store unused dry seasoning in an airtight container in a cool, dark, dry cupboard. For the best flavor, use it within about 6 months; dried spices gradually lose aroma, especially when stored near heat, sunlight, or steam. The blend may remain usable longer if it has stayed dry and smells fresh, but discard it if moisture has gotten into the jar or you notice an off smell. Do not store the dry mix in the refrigerator, where condensation can cause clumping.
Refrigerate cooked taco meat in a covered container within 2 hours of cooking. Use refrigerated leftovers within 3 to 4 days, or freeze them for best quality for about 2 to 3 months. Thaw frozen filling in the refrigerator before reheating when possible. Reheat leftovers on the stovetop over medium heat with a splash of water, stirring until steaming hot; check that the center reaches 165°F. You can also reheat a portion in the microwave, stirring partway through so it heats evenly, and checking the temperature before serving.
Frequently Asked Questions
How much homemade taco seasoning should I use per pound of meat?
Use the full batch in this recipe, about 3 tablespoons, for 1 pound of ground beef. If you prefer a milder flavor, begin with about 2 tablespoons, add water, and taste after simmering before adding more. The strength of chili powder varies, so the first batch is a good opportunity to find your preferred amount.
Can I make the seasoning without salt?
Yes. Leave out the salt and season the cooked filling separately. This is useful if your other ingredients are salty or if people at the table prefer different salt levels. A salt-free blend still gets flavor from cumin, garlic, onion, paprika, oregano, and pepper.
Is taco seasoning the same as chili powder?
No. Chili powder is one ingredient in this blend. In the United States, it often refers to a ready-made blend of ground chiles and other seasonings, while pure ground chile is a single pepper. Taco seasoning combines chili powder with spices such as cumin, garlic, and oregano, plus salt and pepper.
Can I use this seasoning for vegetables?
Yes. Toss chopped vegetables with a little oil and some of the seasoning, then roast or sauté them until tender. Add the blend gradually, since vegetables do not need the same amount as a pound of meat. You can also stir it into warm beans, lentils, or a plant-based ground-meat substitute, adjusting the salt to suit the product.
Can I double or triple the recipe?
Yes. Multiply each spice by the same amount and stir thoroughly in a larger bowl before transferring the mix to a clean, dry jar. For the most even flavor, break up lumps and stir again before each use. When cooking, use about 3 tablespoons of the blend per pound of ground beef, then adjust to taste.
Why did my taco filling turn out dry or too salty?
Dry filling may have simmered too long or started with very lean meat and too little liquid. Stir in water a tablespoon at a time until the texture is moist. If it tastes too salty, add more unsalted meat or beans, or serve it with unsalted rice and fresh toppings; extra water can soften the seasoning but will not remove salt.